UTC TruVision IP Dome Guia de Instalação

TruVision IP Camera Installation Guide P/N 1072668A-EN • REV 1.0 • ISS 24SEP13

10 Installation Guide Figure 2: IP indoor mini dome camera 1. Base 2. Lens 3. Dome liner 4. Housing 5. Ethernet RJ45 and BNC cable 6. Safety

Installation Guide 11 Figure 3: IP wedge camera 1. Cover 2. Lens 3. SD card 4. Ethernet RJ45 PoE port 5. Power supply 6. Base 7. Ser

12 Installation Guide Figure 4: IP VF dome camera 1. Dome liner 2. Housing 3. Ethernet RJ45 PoE port 4. Power supply 5. Audio and alarm ca

Installation Guide 13 For further information, please refer to the “TruVision IP Camera Configuration Manual”. 4. Program the camera to suit its l

14 Installation Guide 2. Secure the mounting base to the ceiling or wall with the supplied screws. 3. Loosen the adjustable nuts on the bracket,

Installation Guide 15 Mounting the VF dome camera To mount the VF dome camera on a ceiling or wall: 1. Loosen the three screws on the edge of the

16 Installation Guide 3. Drill the three screw holes on the ceiling with the supplied drill template. Cable hole Screw holes

Installation Guide 17 4. If you want to route the cables inside the ceiling, drill a cable hole in the ceiling or wall using the drill template.

18 Installation Guide panning position of the camera. Rotate the tilting axes to adjust the tilting position of the camera. Rotate the lens table to

Installation Guide 19 Mounting the indoor mini dome camera To mount the indoor mini dome camera on a ceiling: 1. Drill the screw holes on the ceili

Copyright © 2013 UTC Fire & Security Americas Corporation, Inc. Interlogix is part of UTC Climate Controls & Security, a unit of United

20 Installation Guide Note: If required, you can route cables through the side opening of the mounting base. 4. Loosen the tilt lock screws, and a

Installation Guide 21 5. Reinstall the lower dome and tighten the screws. Mounting the wedge dome camera To mount the wedge dome camera on a ceil

22 Installation Guide 4. Fix the camera base to the converter pan or mounting surface. 5. Re-attach the dome enclosure to the camera. Using the ca

Installation Guide 23 Specifications TruVision IP bullet cameras Electrical Voltage input 12 VDC, PoE (IEEE 802.3af) Power consumption Max. 5 W Mi

24 Installation Guide TruVision IP wedge cameras Electrical Voltage input 12 VDC, PoE (IEEE 802.3af) Power consumption Max. 5 W (Max. 7 W with IR o

Installation Guide 25 Pin definitions There are eight wires on a standard UTP/STP cable and each wire is color-coded. The following shows the pin al

26 Installation Guide Please make sure your connected cables have the same pin assignment and color as above before deploying the cables in your netw

in which case the user may be required to take adequate measures. Canada This Class A digital apparatus complies with Canadian ICES-003. Cet appar

Installation Guide 5 Content Introduction 6Product overview 6Installation 7Installation environment 7Package contents 8Cable requirem

6 Installation Guide Introduction Product overview This is the installation guide for TruVision IP camera models:  TVB-1101 (1.3MPX IP bullet came

Installation Guide 7 Installation This section provides information on how to install the cameras. Installation environment When installing your pro

8 Installation Guide be used for an extended period of time, put on the lens cap to protect the sensors from dirt. Package contents Check the package

Installation Guide 9 Table 1: Recommended power cable requirements Bullet camera: Mini dome: Wedge camera: 12 VDC power jack or PoE (802.3af) PoE (8